Calibration Setup

Media Power Up - The Zebra Printer can be configured to take specific action after power on  The selections vary from calibration to no motion and should be set based on your application and labels you use. Read More>>

Head Close - The Zebra Printer can be configured to take specific action after error recovery (Head Close). The selections vary from calibration to no motion and should be set based on your application and labels you use. Read More>>

The following sensor and calibration related settings should remain as set when the printer is calibrated to the media you are using. Altering these values could result poor media registration or unexpected error conditions. Experience with these settings is required if you are setting values manually.

  • Web Sensor

  • Media Sensor

  • Ribbon Sensor

  • Mark Sensor

  • Mark Media Sensor

  • Transmissive Gain

  • Transmissive Base

  • Transmissive LED

  • Ribbon Gain

  • Mark LED