Viewing The Zebra 10/100 Print Server Configuration Page


There are 3 ways to view the 10/100 Print Server's configuration page after a network connection is made.

1. Test Button on Print Server.

2. Telnet

3. WebView

 

1.    Assure the network cable is connected. Press the Test Button once on the 10/100 Print Server.  The printer will print the configuration information. 

 

Note: The ZM400/ZM600 internal 10/100 Print Server does not have a test button.  Use List Network from the front panel LCD.

            The test button is located between the RJ-45 port and LEDs.

 

        

 

2. Telnet to the IP address of the printer. (A connection must be established to use this method)

From a command prompt type:  telnet x.x.x.x (where x.x.x.x is the IP address of the print server)

You will be prompted for a password.  The default password is 1234.   Choose Option, 1. Show Configuration/Status

3.  You can also view the Print Server II's configuration page from WebView.  Just type in the IP address of the Print Server II in the address bar of your web browser.

Select the link for Print Server Settings, then under Print Server Status select View Configuration Sheet.

You will get an HTML version of the page that can be saved to file and sent to Technical Support if requested.